Livermore, CA: York Eb $950

[arpthark]

https://www.facebook.com/share/18CKHSfsXg/

[York-aholic]

I think these little 15” bell Ebs play pretty well, certainly better than the Monsters, but I wouldn’t pay anywhere near that much. This one is high pitch.


Here is mine that is a mash up of high pitch bugle, low pitch bell and King valves and tubing.

IMG_0375.jpeg (154.5 KiB) Viewed 3371 times

[arpthark]

I think the one in the ad also has the York high pitch/low pitch option loop. Which immediately makes me think of @humBell’s.

[arpthark]

I think these little 15” bell Ebs play pretty well, certainly better than the Monsters, but I wouldn’t pay anywhere near that much. This one is high pitch.


Here is mine that is a mash up of high pitch bugle, low pitch bell and King valves and tubing.



IMG_0375.jpeg

I like the repurposed S arm!

[York-aholic]

Ah, good eye @arpthark , but not good enough


I scribed an old s-arm onto a piece of brass and also made a smaller s-arm to go out to the thumb ‘cylinder’.

Oh, and I put two smaller, more svelte miniball ends on for the linkage since that picture was taken.

[humBell]

I think the one in the ad also has the York high pitch/low pitch option loop. Which immediately makes me think of @humBell’s.

So... it is high pitch by choice?

I always have trouble pushing the closed loop in all the way when it is not being used...

[arpthark]

I think the one in the ad also has the York high pitch/low pitch option loop. Which immediately makes me think of @humBell’s.

So... it is high pitch by choice?

I always have trouble pushing the closed loop in all the way when it is not being used...

Yes. Too bad it doesn’t have a water key that you could depress when closing it to equalize the pressure.

I’d probably install one on the top crook, to make it extra puzzling to people not in the know.