They must have had some way to do it. I’ve seen a few Martin catalogs that specifically say that other sized bells are available on custom order. If it was a huge pain, I doubt they would have mentioned it in the catalog, but rather grumbled a bit then did it for ‘special’ customers only.
King cut 19” upright bells down to 16” for William Bell and Abe Torchinsky for their rotary CC tubas.
However, you’re right, my “trivial” comment was a bit off.
Holton Del Negro BB-flat tubas
Forum rules
This section is for posts that are directly related to performance, performers, or equipment. Social issues are allowed, as long as they are directly related to those categories. If you see a post that you cannot respond to with respect and courtesy, we ask that you do not respond at all.
This section is for posts that are directly related to performance, performers, or equipment. Social issues are allowed, as long as they are directly related to those categories. If you see a post that you cannot respond to with respect and courtesy, we ask that you do not respond at all.
-
York-aholic
- Posts: 1432
- Joined: Thu Aug 13, 2020 10:39 pm
- Location: SoCal
- Has thanked: 1552 times
- Been thanked: 467 times
-
bloke
- Mid South Music
- Posts: 19270
- Joined: Thu Aug 13, 2020 8:55 am
- Location: western Tennessee - near Memphis
- Has thanked: 3835 times
- Been thanked: 4080 times
Re: Holton Del Negro BB-flat tubas
I'm not nitpicking. I really don't know much, but I've been told that by someone who watch tuba bells being spun and talked to those bell spinners about different diameters of pancakes.
The farthest I've ever been onto the European continent was the Netherlands, and Adams was only making drums back then.
The farthest I've ever been onto the European continent was the Netherlands, and Adams was only making drums back then.
- These users thanked the author bloke for the post:
- York-aholic (Wed Nov 06, 2024 6:34 am)