SOLD - Walt Johnson Case
Posted: Mon Jul 19, 2021 7:12 pm
I have a Walt Johnson built-like-a-tank "flight case" I bought used a few years ago and never got around to up-fitting for the two CC or the F horns I've owned since. Not sure what the previous owner shipped with it, but Nirschl 5/4 seems to come to mind.
Interior padding and fabric is all excellent, exterior has scuffs and dings but no damage. The large and excellent latches function very well. The added/modified metal wheel mounts and wheels may appear small and weak but are actually stout and work well, though the big case can be tippy.
I have attached a few pics and have more. Pics show inside dimensions below. “Depth” measurements are from valance edge to case wall. There are also what I would call "pillow" pads where I show a depth measurement from valance edge to the top of pillow then an additional "thickness" measurement of the pillow itself from top to bottom.
I recently tried out my Eastman 6/4 in the case, I aligned the horn where the red lines are in dimension photo, it worked fine overall except bell rim was a little close to the outside edge, but I think padding could be modified to adjust it inward to accommodate it very well.
Good STRONG case priced at $400, the case is currently in South Dakota, the shipping method is TBD depending on your location (see post below regarding shipping.)
Thanks!
Interior padding and fabric is all excellent, exterior has scuffs and dings but no damage. The large and excellent latches function very well. The added/modified metal wheel mounts and wheels may appear small and weak but are actually stout and work well, though the big case can be tippy.
I have attached a few pics and have more. Pics show inside dimensions below. “Depth” measurements are from valance edge to case wall. There are also what I would call "pillow" pads where I show a depth measurement from valance edge to the top of pillow then an additional "thickness" measurement of the pillow itself from top to bottom.
I recently tried out my Eastman 6/4 in the case, I aligned the horn where the red lines are in dimension photo, it worked fine overall except bell rim was a little close to the outside edge, but I think padding could be modified to adjust it inward to accommodate it very well.
Good STRONG case priced at $400, the case is currently in South Dakota, the shipping method is TBD depending on your location (see post below regarding shipping.)
Thanks!