FS: Conn Monster Eb Bell (cut)
Posted: Fri Mar 15, 2024 3:02 pm
Hello,
For sale is the Conn Monster Eb bell I botched cutting while making my helicon. I cut it too short and so it wouldn't fit in the tenon. This would be good for making a detachable bell for something (King, Conn, maybe) if you've got the male tenon. It's fairly smooth, though it's got plenty of scratches, tarnish, and small dings/dimples. One side is a little bit flat and the bell rim isn't perfectly straight. The flare is 20" and the small end is between 5 1/8" and 5 3/8." There is a spot where I tried snipping it and folding it over a bit to get it to work, but alas, it didn't. It is 20 7/8" tall.
I'm asking $150 plus the costs of packaging and shipping. It's located in Lincoln, NE. Below are a few photos plus a link to google folder with more.
You can contact me via PM here or jordanhluke (at) yahoo (dot) com.
Botched Bell Google Drive Photos
Here it is just sitting inside a King bell stack to show that it could make a good detachable bell:
For sale is the Conn Monster Eb bell I botched cutting while making my helicon. I cut it too short and so it wouldn't fit in the tenon. This would be good for making a detachable bell for something (King, Conn, maybe) if you've got the male tenon. It's fairly smooth, though it's got plenty of scratches, tarnish, and small dings/dimples. One side is a little bit flat and the bell rim isn't perfectly straight. The flare is 20" and the small end is between 5 1/8" and 5 3/8." There is a spot where I tried snipping it and folding it over a bit to get it to work, but alas, it didn't. It is 20 7/8" tall.
I'm asking $150 plus the costs of packaging and shipping. It's located in Lincoln, NE. Below are a few photos plus a link to google folder with more.
You can contact me via PM here or jordanhluke (at) yahoo (dot) com.
Botched Bell Google Drive Photos
Here it is just sitting inside a King bell stack to show that it could make a good detachable bell: